Some years back I bought some real cheap 600A and 800A IGBT bricks. These will be used in a very large DRSSTC along with the film capacitors you saw yesterday in the day 2 video.
8x 800A + 8x 600A IGBT Bricks – Isolation, Day 3 Read More »
A while back I received a large lot of capacitors that I got for a fair price, just had to buy enough to get the per item cost of shipping down to an acceptable level. The base price per capacitor is more than reasonable in the first place, just a mere 1€ a piece! I
25x 350uF/1500V Film Capacitors – Isolation, Day 2 Read More »
I flip through the most interesting sections of high voltage gear and equipment from manufacturers like Sebamkt, Megger, Glassman and others. Denmark went into a 2 week corona virus lockdown today. This huge advertising material has been sitting on my desk for far too long. Now was the time to show the content you, my
High Voltage Equipment Catalog – Isolation, Day 1 Read More »
This is part 3 of my DIY LED flood light that is going to be used for high speed video filming with the FPS1000HD camera. In this video, I measured the lux value to 25000 at 1 square meter which corresponds to the given lumen value for the LED COBs. The 36VDC power supply voltage
DIY 250W LED Flood Light for High Speed Filming, Part 3 of 3. Read More »
This is part 2 of my diy led flood light that is going to be used for high speed video filming with the FPS1000HD camera. It should be able to deliver around 20000-25000 Lumen. Here I modify 3x HP server power supplies to deliver 36VDC, add fan controllers for the heat sinks and box it
DIY 250W LED Flood Light for High Speed Filming, Part 2 of 3. Read More »
This is part 1 of my flood light project, that is going to be used for high speed video filming with the FPS1000HD camera. It is being built form 5x 50W LED COBs mounted on old Pentium4 CPU coolers. I got no affiliation with these sellers, but it is where I bought my parts: 50W
DIY 250W LED Flood Light for High Speed Filming, Part 1 of 3. Read More »
This is the first upgrade for the Anet A8 3D printer. A new power supply from a HP server will be a fire-hazard reducing upgrade. The original PSU is a undersized and over-specified power supply, that came with the printer. 12V @ 62A is of cause much more powerful than needed for the Anet A8.
Anet A8 3D Printer Upgrades: 12V Power Supply From a Server Read More »
This is the unboxing of a Anet A8 3D printer that was bought for my father to experiment with. Hopefully this will give some good help to make parts for electronics as part of the diy way of life 🙂 Following videos, in the future, will be about 3D printer upgrades to the printer and
Anet A8 3D Printer Unboxing Read More »