Server PSU Hack – HP DPS-800GB A, 12VDC 1000W

A guide on how to make the, HP DPS-800GB Rev. A, server power supply run outside of its server enclosure.

A simple bridge between pin 31 and 34 is required and it is important to NOT drill holes through the GND and +12VDC output pads, this will risk short-circuiting the output as its a 4-layer PCB.

Mads Barnkob

Electrician, programmer, experimenter and amateur scientist with experience in industry automation, programming and all kinds of high voltage generating electronics. Administrator of www.kaizerpowerelectronics.dk and the high voltage community forum www.highvoltageforum.net

View all posts by Mads Barnkob →

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.