Yearly Archives: 2012

Another TV lives again!

Posted on October 30, 2012 by Mads Barnkob

I received a broken 27″ LCD TV and repaired it. Read the whole article in order to see how it was done and how cheap it was done. http://kaizerpowerelectronics.dk/general-electronics/27-lcd-tv-repair/

Posted in Electronics | Leave a comment

4000 joule capacitor bank fired at maximum energy

Posted on August 11, 2012 by Mads Barnkob

This afternoon I had my current monitor and oscilloscope hooked up to the capacitor bank to do current measurements of the short circuit energy. The results and pictures are amazing and I am thrilled by the magnitude of the pulse … Continue reading →

Posted in High voltage | Leave a comment

First shot with 4000 joule capacitor bank!

Posted on August 5, 2012 by Mads Barnkob

Today I put the last parts together on small project with a large impact. A 4000 joule capacitor bank able of delivering destructive short circuit currents in the thousands. The first test was only done at 1kj to ensure that … Continue reading →

Posted in High voltage | 1 Comment

Finn Hammer and Daniel Uhrenholt show in Fredericia, Denmark.

Posted on June 2, 2012 by Mads Barnkob

I went to visit Finn Hammer and Daniel Uhrenholt when they were doing a show in Fredericia, Denmark at Tøjhuset as a part of a electrical car and alternative energy convention. A few pictures from around the event. Among a … Continue reading →

Posted in Tesla Coils | Leave a comment

Kaizer DRSSTC III – progress update #2

Posted on May 20, 2012 by Mads Barnkob

Here is an update with work that have been done last week on the large DRSSTC. This update will show you half of the mmc, the enclosure, the platform, new primary supports and the wound primary coil. Read the article … Continue reading →

Posted in Tesla Coils | Leave a comment

Kaizer DRSSTC II playing Doom 1 – Episode 1

Posted on February 14, 2012 by Mads Barnkob

First song played on one of my DRSSTCs is the legendary soundtrack from Doom 1 – Episode 1, this is not only cool but brings me back to a childhood where it was normal to run around with a chainsaw … Continue reading →

Posted in Tesla Coils | Leave a comment

Kaizer DRSSTC III – progress update

Posted on January 13, 2012 by Mads Barnkob

Here is a small update with some of the work that have been done on the large DRSSTC. This is my first project where I will post information and pictures about the progress as the project goes along. Normally I … Continue reading →

Posted in Tesla Coils | Leave a comment